Saturday, November 21, 2020

Stripping screws on Omen 15 Laptop

Use a Philips Head #000 (PH000) screw driver to remove the screws. I made the mistake of using #0 and #00, using a common precision screw driver set from Walmart, which stripped it for the tougher front screws. HP uses thread locking glue so it is hit or miss for successful extraction without the proper screwdriver head. If the screw does not come out easily, stop! If this message is too late as you have already stripped it, screwdriver just spins freely and you can see silver, use a Microbit Screw Extractor (the smallest one in the set) with a power drill. Install the bit, set the drill on reverse, set the lowest speed or infinite with a slow press. Pressing down firmly on the screw head start with the side having the big teeth. If it bites the screw will extract. In my case I did not even have to use the other side with more threads. As for replacement screws, there are laptop screw sets you can buy from Amazon and such. For the 2018-2020 Omen 15 the outer case screws are M2x6.0.

(PAID link) Microbit Screw Extractor (Amazon)
(PAID link) Assorted Laptop Screws (Amazon)
(PAID link) Screwdriver set containing PH000 (Amazon)

Saturday, November 14, 2020

Why Is my Mic not recorded on OBS Stream?

So I checked all the usual suspects: Mic audio levels were moving, unchecked exclusive mode on microphone, made sure microphone was not muted in Windows or OBS, verified desktop audio could be heard on the stream. But somehow OBS was not sending my Mic/Aux to either the Stream or Recording. Discord had no issue picking up my voice so it had to be something in OBS. Clicked on Advanced Properties on the Mic/Aux under Audio Mixer. I see that track 1 was assigned to Desktop Audio while track 2 was set for the Mic/Aux. So I clicked Track 1 on the Mic/Aux as well, magically the recording now has sound. I notice that the track selector on Stream is a radio button, only one can be active.
UPDATE: Found a similar issue in the OBS Forum

Saturday, August 1, 2020

Easiest Way of Removing Ferrero Rocher Labels from Jewel Boxes

Clear containers are good for storing things and seeing immediately what is in them. These chocolate boxes always seemed a shame to throw away. Here is an easy way to remove the labels

Tools needed:
  • Packing Tape
  • Vegetable Oil
  • Soap and Water

Removing the Logo under the Cover:

  1. Flip the cover over to access the logo underneath the cover.
  2. Cut a length of packing tape to cover as much of the logo as possible.  Leave enough on the sides so you can pull easily.
  3. Press the tape unto the logo firmly.
  4. Peel the tape off the cover, the logo should come off with it.
  5. Repeat until clean.

Removing the Sticker on Bottom Right:

  1. Use fingernails or a spoon to lift the edges of the sticker label.
  2. Get some vegetable oil (unused) and smother the label.
  3. Be generous around the edges so the oil can seep into the adhesive layer.
  4. Let sit for about an hour.
  5. Gently peel from one end of the sticker.
  6. Wash with soap (the blue Dawn is best) to remove oil and leftover adhesive.
  7. Let dry.